25VI4625 Roller Needle Bearing 25x46x25mm MH044080 ISO2000 Certification

25VI4625 MITSUBISHI CANTER 657 Needle Roller Bearing 25x46x25MM MH044080

Needle roller bearing Specification  

Needle Roller Bearing Description

The outer ring of drawn cup needle roller bearing is punched with the steel sheet. It has the small sectional height and the large load carrying capacity and is suitable for economic mass production.

The interference fit between outer ring and bearing housing is applied to this kind of needle roller bearing without axial fixing device. Even for the condition of high load, it fully maintains bearing function either. In addition, with the large grease-storage capacity, it is unnecessary to add grease for a long-term operation.

Since one end of the close-end bearing is sealed, it is suitable for the end of shaft with bearing the small axial sliding force.

Model HK, TA, TLA, open-end drawn cup. needle roller bearings with retainer,

Model BK close-end drawn cup needle roller bearing with retainer,

Model SCE, BA, J, JH, drawn cup needle roller bearings (Inch series).

Needle Roller Bearing​ Number

Needle Roller Bearing  Delivery

The installation of full complement needle roller bearings is usually carried out using auxiliary sleeves. At this time, the auxiliary roller or auxiliary sleeve supports the needle roller to prevent it from falling out, and the journal lifts the needle roller with its own chamfer. As the needle bearing moves slowly inward on the journal, the auxiliary roller Or the auxiliary sleeve will slowly withdraw until it is installed in the working position.

The outer diameter of the auxiliary roller and auxiliary sleeve should be 0.1-0.3mm smaller than the shaft diameter. When installing, first apply grease to the inner surface of the outer ring of the bearing, and put the needle close to the inner surface (a gap should be left when the last needle is inserted).