Application scope:

Vulcanization tank is mainly used for rubber tire retreading, reclaimed rubber desulphurization, wire, cable, tape, rubber rollers and other rubber products vulcanization. styrene-butadiene rubber thermoplastic refining, wood, Chinese medicine sterilization, oxidation of aluminum products, carbonization of bamboo products widely used in the gypsum and its products and other materials autoclaving.

The features of the autoclave for tyre retreading:

The autoclave for tire retreading is a pressure vessel with speed open door, the autoclave openings sealed with inflatable silicone ring or internal pressure self-tight rubber pad. Mechanical or manual gearing is used to lock and open the lid, reasonable structure, convenient operation, good sealing performance, the temperature in the tank is uniform,furthermore, complete safety accessories (equipped with safety interlock device).

1. Introduction

1. Vulcanizing pot design and manufacture in strict accordance with the national standard of "" steel pressure vessel, and according to the country" pressure vessel safety design review project "the relevant requirement of inspection.

2. According to the heating mode can be divided into steam pressure, electrical heating and heat conduction oil heating three forms.

3. According to different division control circuit for PLC control and PLC control add touch screen display two kinds.

2. Equipment features

1. Tyre renovating lower the production cost

2. Can be devided into single or multiple tyre vulcanizin

3. Warming up, vulcanize time, pressure, aerate, exhausting are all automatic control

4. Temperature in the vulcanizer is evenly, balance control of every single tyre pressure, ensure the hardness, strength, elasticity of the product no deformation

5. Opening door adopt safety interlock, have passed the identification by Provincial Technical Supervision.

3. Operation

Manual closing, vulcanizing pot after is open, the power is connected by hand motor door-close button, vulcanizing pot began to enter into automatic control.

1) miniature cooling motor startup

2) the circulation fan startup

3) heater or steam heating begin

4) vacuum pump start-up

5) 0.75 M afraid of filtering dry air valve opens(into the cans of compressed air should be no oil dry compressed air) until vulcanizing pot pressurized to setting value, to date, heater, self-control after fan, EPS value to package sets the set pressure value will suffer. Vulcanizing pot in which meets the above conditions launched. After timer General vulcanization time is 2.6-3 hours. Achieve time vulcanizing pot automatic vent, until the compressed air all platoon tank to tank clean, pressure value zero, open the door motor automatically start make pot the doors opened, as the entire system without electricity, vulcanization ended.

4. Technical parameters